4 KiB
| stage | group | info |
|---|---|---|
| Systems | Distribution | To determine the technical writer assigned to the Stage/Group associated with this page, see https://about.gitlab.com/handbook/engineering/ux/technical-writing/#assignments |
How to restart GitLab (FREE SELF)
Depending on how you installed GitLab, there are different methods to restart its services.
NOTE: A short downtime is expected for all methods.
Omnibus installations
If you have used the Omnibus packages to install GitLab, then
you should already have gitlab-ctl in your PATH.
gitlab-ctl interacts with the Omnibus packages and can be used to restart the
GitLab Rails application (Puma) as well as the other components, like:
- GitLab Workhorse
- Sidekiq
- PostgreSQL (if you are using the bundled one)
- NGINX (if you are using the bundled one)
- Redis (if you are using the bundled one)
- Mailroom
- Logrotate
Omnibus GitLab restart
There may be times in the documentation where you are asked to restart GitLab. In that case, you need to run the following command:
sudo gitlab-ctl restart
The output should be similar to this:
ok: run: gitlab-workhorse: (pid 11291) 1s
ok: run: logrotate: (pid 11299) 0s
ok: run: mailroom: (pid 11306) 0s
ok: run: nginx: (pid 11309) 0s
ok: run: postgresql: (pid 11316) 1s
ok: run: redis: (pid 11325) 0s
ok: run: sidekiq: (pid 11331) 1s
ok: run: puma: (pid 11338) 0s
To restart a component separately, you can append its service name to the
restart command. For example, to restart only NGINX you would run:
sudo gitlab-ctl restart nginx
To check the status of GitLab services, run:
sudo gitlab-ctl status
Notice that all services say ok: run.
Sometimes, components time out (look for timeout in the logs) during the
restart and sometimes they get stuck.
In that case, you can use gitlab-ctl kill <service> to send the SIGKILL
signal to the service, for example sidekiq. After that, a restart should
perform fine.
As a last resort, you can try to reconfigure GitLab instead.
Omnibus GitLab reconfigure
There may be times in the documentation where you are asked to reconfigure GitLab. Remember that this method applies only for the Omnibus packages.
Reconfigure Omnibus GitLab with:
sudo gitlab-ctl reconfigure
Reconfiguring GitLab should occur in the event that something in its
configuration (/etc/gitlab/gitlab.rb) has changed.
When you run this command, Chef, the underlying configuration management application that powers Omnibus GitLab, makes sure that all things like directories, permissions, and services are in place and in the same shape that they were initially shipped.
It also restarts GitLab components where needed, if any of their configuration files have changed.
If you manually edit any files in /var/opt/gitlab that are managed by Chef,
running reconfigure reverts the changes and restarts the services that
depend on those files.
Installations from source
If you have followed the official installation guide to install GitLab from source, run the following command to restart GitLab:
# For systems running systemd
sudo systemctl restart gitlab.target
# For systems running SysV init
sudo service gitlab restart
This should restart Puma, Sidekiq, GitLab Workhorse, and Mailroom (if enabled).
Helm chart installations
There is no single command to restart the entire GitLab application installed via
the cloud native Helm Chart. Usually, it should be
enough to restart a specific component separately (for example, gitaly, puma,
workhorse, or gitlab-shell) by deleting all the pods related to it:
kubectl delete pods -l release=<helm release name>,app=<component name>
The release name can be obtained from the output of the helm list command.